Liste des articles

Pro Edger 5types (Includes: Edger sharpening rod/ Water resistant paper)

Pro Edger 5types (Includes: Edger sharpening rod/ Water resistant paper)
プロ・へり落とし(刃幅5種類)研ぎ棒・耐水ペーパー付 
プロ・へり落とし(刃幅5種類)研ぎ棒・耐水ペーパー付 
プロ・へり落とし(刃幅5種類)研ぎ棒・耐水ペーパー付 

nom de l'article

Pro Edger 5types (Includes: Edger sharpening rod/ Water resistant paper)

Prix / tarif

No.0 ¥1,900JPY
No.1 ¥1,900
No.2 ¥1,900
No.3 ¥1,900
No.4 ¥1,900

Taille

No.0(0.6mm)/ No.1(0.8mm)/ No.2(1.0mm)/ No.3(1.2mm)/ No.4(1.4mm) ( )=The blade width

Utilisation

Trimming and smoothing edges of leather

Caractéristiques

It has been commonly accepted on the market that Edge Bevelers have dull blades. The finish quality of the edge is one of the most important parts for leather craft so we created these tools in response to user’s expectations.

①Our artisan sharpens the blades on a one by one basis and tests them on leather sheets, to make sure that it cuts very well. We ship the tools, putting oil on to the blades to prevent rust and cover it with a vinyl tube to protect it.

②Using tool steel, tempered whole tool, gray coating prevents rust.

③Engraving the size number and “MADE IN JAPAN” (Total 5 variations)

How to resharpen the blade:
If you feel the blade sharpness is becoming dull, you can polish the blade part with leather sheet and polishing compound.
Rub Polishing compound and a few drops of oil on the trimmed edge of the leather sheet, put the blade part on the leather and pull off at a fixed angle and polish the blade.
If you can’t get the sharpness with the process above, you can use the attached Sharpening Rod and Water resistant paper.
Putting the paper on the Rod adding some drops of water, pulling off the blade part along the Rod and polish the blade.
If you can’t sharpen the blade well, you can use our “Resharpen blade business”.
(“Resharpen blade business” is mentioned in OKA FACTORY’s 4 commitments)

Usage & Maintenance

Manuel d'utilisation

N'hésitez pas à nous poser vos questions et à nous demander un devis.

N'hésitez pas à nous poser vos questions et à nous demander un devis.
Fabrication et vente d'outils pour le travail du cuir. Outils japonais de qualité professionnelle pour le travail du cuir. Oka Factory & Co.,Ltd.

Oka Factory & Co.,Ltd.

272-0827 5-10-7, Konodai, Ichikawa-city, Chiba

tel
+81-47-713-8601

Du lundi au vendredi de 8h30 à 18h00

FAX +81-47-713-8661

Pour toute commande, vous pouvez nous envoyer un email, nous téléphoner ou nous envoyer un fax.
Nous sommes fabricant, si l'article que vous souhaitez n'est pas en stock et doit être fabriqué, cela peut donc prendre un peu de temps.

Oka factory Instagram Oka factory Facebook

Translate »